Page 3 - Aerocel Aerofit Fitting Covers

FITTING COVERS
...................................................................................................
KEY FEATURES NOW E84 25/50
4
Easy to Install – Lowers Installation Costs,
Increases Project Quality – Keeps Job Costs as
Estimated
4
UV Resistant – Added Weather Protection
Not Required, Saves on First Cost and Maintenance
4
Lower Thermal Conductivity – Saves Additional
Energy Costs
4
257
° Upper Use Limit – Greater Application
Range – Cryogenic to Low Pressure Steam
4
E 84 25/50 to 2” Thickness – Lowers
Installation Costs with Fewer Layers
4
Versatile for Heating, AC, Refrigeration, Solar,
Plumbing – Single Product for All Systems
......................................................................................................................
RESISTANCE TO MOISTURE VAPOR FLOW
............................................................................................................................................................
APPLICATIONS
AEROFIT
The unique cell structure of Aerocel
®
EPDM Insulation effectively retards the flow of moisture
vapor. Aerocel is considered a low transmittance vapor retarder. In normal service conditions,
Aerocel requires no supplemental vapor retarder protection. When used in extremely low-temperature
or extremely high-humidity conditions, an additional vapor barrier maybe required.
Aerocel
®
AeroFit
®
Elastomeric Insulating Fitting Covers are to be installed prior to straight-run pipe insulation.
For systems operating below-ambient temperature, Aerocel
®
AeroFit
®
Elastomeric Insulating Fitting Covers are
designed to be slit open, installed on the pipe fitting to be insulated, then sealed closed using Aeroseal
®
adhesive.
The use of Aeroflex’s Protape
®
to finish the glued seam is optional. For systems operating above-ambient
temperature, Aerocel
®
AeroFit
®
Elastomeric Insulating Fitting Covers are designed to be slit open, installed on
the pipe fitting to be insulated, then sealed closed, using either Aeroseal
®
Adhesive or Aerocel
®
Protape. In no
case, is PVC, duct, or electrical tape an acceptable closure product. The straight-piping insulation is then butted,
with a slight compression fit, to the AeroFit
®
fitting cover. Butt joints are to be sealed with contact adhesive on below-
ambient and above-ambient systems, with the option of using only Aerocel
®
Protape on above-ambient systems.
Aerocel
®
is designed for installation above and below ground,
indoors and outdoors. No protective finish is required.