Page 2 - Aerocel Aerofit Fitting Covers

ELASTOMERIC INSULATIN
.................................................................................................................................................
USES
Aerocel
®
AeroFit
®
Elastomeric Insulating Fitting Covers are used to retard heat gain or loss,
and to control condensation formation on cold-water plumbing, chilled water, and
refrigeration line elbows and suction line P-Traps. AeroFit
®
Elastomeric Insulating Fitting
Covers more efficiently reduce heat flow on hot water plumbing, liquid heating, and
dual-temperature piping fittings by maintaining a full thickness of Aerocel insulation
over the whole surface area of the fitting. Aerocel
®
AeroFit
®
Elastomeric Insulating
Fitting Covers avoid the common pitfalls of installation associated with sliding
elastomeric insulation over piping fittings. The recommended service temperature
range for Aerocel Insulation is -297°F to +257°F.
Aerocel
®
is designed for installation above and below ground,
indoors and outdoors. No protective finish is required.
Aerocel
®
AeroFit
®
Elastomeric Insulating Fitting
Covers are uniquely suited to dual-temperature
HVAC piping systems. This unique fit results
from Aerocel’s proprietary combination of
very low moisture vapor flow for times of
cooling-mode operation, higher temperature
usage properties during times of heating-mode
operation, and superior insulating capacity in
either operating mode. Aerocel
®
AeroFit
®
Elastomeric Insulating Fitting Covers are uniquely
suited to Solar piping systems because of the proprietary combination
of UV Resistance, greater thermal efficiency, non-corrosiveness to
copper or stainless steel, and availability as single layer product
in greater thicknesses.
AeroFit® Suction Line P-Trap Covers are specifically designed
to fit Mueller Industries Streamline® Suction Line P-Traps.
Aeroflex USA, Inc. will not warrant the fit of this insulating fitting cover for any other manufacturer’s suction line P-Trap.
AEROFIT